10PCS TTP223B Digital Touch Sensor Capacitive Touch Switch Module For Arduino

Description

The module is based on a touch-sensing IC (TTP223B) capacitive touch switch module. In the normal state, the module output low, low power consumption; When a finger touches the corresponding position, the module output high, if not touched for 12 seconds, switch to low-power mode. Allows you to remove the worry of conventional push-keys. Digital Capacitive Touch Switch Module is based on TTP223B. Normally, it outputs low and keeps at low power state. When a touch is sensed on the circular marked region, it outputs high and switches to the quick response state. When not being touched for 12 seconds, it switches to low power state again. If the module is mounted in the surfaces of non-metallic materials such as plastic, glass, acrylic, you can make the keys hidden in the walls and desks. In addition to the thin paper ( non-metallic ) covering the surface of the module, as long as the correct location of the touch, you can make hidden in the walls, desktops and other parts of buttons. Touch Sensor Interface: Control Interface: A total of three pins (GND, VCC, SIG), GND to the ground, VCC is the power supply, SIG digital signal output pin Power Indicator: Green LED, power on the right that is shiny Touch area: to a fingerprint icon inside the area, you can touch the trigger finger. Positioning holes: 4 M2 screws positioning hole diameter is 2.2mm, the positioning of the module is easy to install, to achieve inter-module combination. Features : Low power consumption Power supply for 2 ~ 5.5V DC Can replace the traditional touch of a button Four M2 screws positioning holes for easy installation Output Pin Sink Current (@ VCC = 3V, VOL = 0.6V) : 8 mA Output pin pull-up current (@ VCC = 3V, VOH = 2.4V) : 4 mA
Specification
:
Power supply voltage VCC range:2.0--5.5V
Output high VOH:0.8VCC
Output low VOL:0.3VCC
Output Pin Sink Current (VCC = 3V, VOL = 0.6V):8mA
Output pin pull-up current (VCC = 3V, VOH = 2.4V):4mA
Response time (low power mode):220mS
Response time (touch mode):60mS
Size:24*24*7.2MM
Weight:2g
Features
:
Low power consumption
Power supply for 2 ~ 5.5V DC
Can replace the traditional touch of a button
Four M2 screws positioning holes for easy installation
Package Included:
10PCS TTP223B Digital Touch Sensor Capacitive Touch Switch Module For Arduino
Instructions/schematic are NOT included. We don't provide technical assistance please make sure that you are familiar with the product before purchasing.